Ditch the disposables and swap to a Safety Razor
This gorgeous Stainless Steel safety razor is the only razor you will ever need.
The handle unwinds allowing you to place a safety blade into the head.
The razor comes with 5 free blades to get you started.
This razor will save you a fortune over the years in shaving, its kinder to your skin and will not pollute the planet like a disposable plastic razor.
Sourced by In Greens, this razor made in a small family owned and managed factory in Pakistan where the employees (of which there are just 3) are all paid above the national minimum wage, in a very small factory and work 5-days per week, 8-hour days with 1-hour lunch breaks.
Good to Know:
- Plastic free and packaged in 100% recycled materials
- Kinder to your skin.
- Will not pollute the planet like a disposable plastic razor.
- 5 x replacement blades
If you’ve never changed a blade you find exactly how to here Changing a Safety Razor Blade
Note – As it’s illegal to sell Razor Blades to anyone under the age of 18 Under the Criminal Justice Act 1988, proof of identity will be needed before your order is sent out. Don’t worry if you place an order I’ll drop you a quick email to let you know what you need to provide and it shouldn’t delay your order.
How to Use
How To Use
It’s best to use the razor after you’ve showered or applied a hot towel to your face/area that you want to shave before to soften skin.
The first thing you need to do, is soak your shaving brush in warm water for 30 seconds.
Soften the shaving soap by putting a little warm water onto it.
Squeeze the excess water out of your shaving brush. If you have too much water in the brush, it’ll make for thin, frothy, lather. Not enough water and it will be hard to develop lather at all.
Load the brush, you do this by gently swirling the brush around on the surface of the soap for a minute or two — until you notice a good creamy lather start to form. You alternate the swirl direction (between clockwise and counter-clockwise) every few moments to help work the lather into the brush’s bristles.
Paint the area you want to shave with the lather using the shaving brush. You can use back-and-forth strokes, up-and-down strokes, swirly strokes, or a combination.
Safety razors can take some getting used to and there is a technique to it, this can take time but you’ll get it soon enough. All you need to do while you are getting used to it choose when to shave carefully, as in don’t try this the morning of a job interview or in a hurry.
So pull the skin taut in the opposite direction of the blade, and hold the razor at about thirty degree angle. Remember not to apply any pressure, and use short, even strokes, going with the grain of your hair.
Replacing the Blades
You’ll know it’s time to toss a blade when it starts to tug or pull on the first couples of strokes. But remember you can use both side of the razor. Depending on your beard/hair thickness, that could be every other day or once a week.
To change the blades hold the razor head with one hand and then twist handle counter clockwise.
Remove the bottom plate from the razor head and then drop the blade on top of the pegs.
Then place the bottom plate back over the blade, hold the top and bottom of the head together, insert handle back into the head and then twist clockwise.